i know the answer must be fairly simple, but it's got me!
i'm building slot absorbers at a 6 degree angle and i need to bevel some strips of 2x2 at 6 degrees along one edge. i have a mitre saw that can do skirting etc. but i can't figure out how to do a long strip!
anticipating an embarrasingly easy solution,
jon
simple? carpentry question
-
- Posts: 23
- Joined: Tue Apr 29, 2003 11:24 am
- Location: Leeds, UK
-
- Senior Member
- Posts: 1476
- Joined: Sat Jun 21, 2003 2:42 am
- Location: Henderson County
- Contact:
-
- Senior Member
- Posts: 6976
- Joined: Sun Mar 16, 2003 11:11 am
- Location: West Coast, USA
Jon, I'm not sure if you're talking about a hand miter saw or a powered one, but neither one will do what you want. As Bryan said, a table saw - or radial saw, jointer, band saw - even a hand circular "skil" saw if you're careful.
Other than that, you might have to hire it done at a local cabinet shop that has tools like that... Steve
Other than that, you might have to hire it done at a local cabinet shop that has tools like that... Steve
Soooo, when a Musician dies, do they hear the white noise at the end of the tunnel??!? Hmmmm...