John Sayers' Recording Studio Design Forum Archive

Hey guys.

Iv been lurking around the forums for a while now and have finally decided to post with some questions for my control room.
It is a rectangular form but the corners are often obstructed and is therefore hard for me to get full floor to ceiling trapping installed. I could really use some advice on how to set my room up.

Iv attached a google sketchup model of it and hopefully this is useable.

Thanks a lot and any info would be great.

Bond

I'd suggest you check the stickies.

Don't have much time. Without much info on your room, here is some econo suggestions. I'm sure someone can explain them if need be. But I'm positive there will be an alternative view as well.
These may be moot depending on what you post after reading what soundman said to read.
Also, I didn't know what that opening at the bottom corner by the corner column was. I just filled it.
BTW, the color is only for contrast to see the panels etc.
Anyway, heres some ideas.

Gotta go.
fitZ














fitZ

habsrule30 wrote:Hey guys.

Iv been lurking around the forums for a while now and have finally decided to post with some questions for my control room.
It is a rectangular form but the corners are often obstructed and is therefore hard for me to get full floor to ceiling trapping installed. I could really use some advice on how to set my room up.

Iv attached a google sketchup model of it and hopefully this is useable.

Thanks a lot and any info would be great.

Bond

Bond,

Please read the forum RULES (stickies) that can be found at this link:
http://www.johnlsayers.com/phpBB2/viewforum.php?f=17

Please correct your initial post to conform with these rules and guidelines. Many here will not only NOT help while waiting in respect for owners and other better qualified persons to proceed, but will simply ignore these type of posts completely.

You may want to immediately ask "what is it that I have missed". Most often it is as simple as including your geographical location in your profile.

Trust me in that the more you know the better others can help you and that the answer to that question is in the forum rules linked page.


Until then, good luck,


Brien