Vocal Booth Design
-
- Posts: 1
- Joined: Tue Jun 30, 2020 12:41 pm
- Location: Nashville, TN, USA
Vocal Booth Design
Good evening. I'm working on building a vocal booth with non parallel walls based on a design made by Vocalbooth Inc. What I am struggling with in my mind is how to connect the parts of the wood frame for my floor that aren't at a 90 degree angle. I'm aware of miter saws only cutting about 45-50 degree angles. Is anyone able to give me some suggestions? I've attached pictures of the dimension. I'm looking to create the 10 carat one.
-
- Moderator
- Posts: 5344
- Joined: Wed Jul 13, 2005 3:55 am
- Location: Panama City Beach, FL USA
- Contact:
Re: Vocal Booth Design
not sure if this response matters now but here goes:
you can think of the booth as multiple flat panels, and you connect them with ripped 2x or 4x lumber to facilitate joining the panels. see example.
you can think of the booth as multiple flat panels, and you connect them with ripped 2x or 4x lumber to facilitate joining the panels. see example.
Glenn