Page 1 of 1
Door Question
Posted: Sat Apr 30, 2005 1:23 am
by Lbc
My studio walls are going to be 2 2X4 framed walls w/2 layers of drywall on both outside faces. My plan for the door frames is to span the 2 2X4 wall's with a limp mass rubber type material around the frame to seal the air gap between the walls, then have two door frames that do not touch. Does this sound correct.
Posted: Sat Apr 30, 2005 10:17 am
by knightfly
Not quite; you will actually get better performance overall if you use something more "breathable" around the doors, allowing the air between them to "vent" into and out of the space between the walls, moving thru the insulation in the process.
You're right about the two frames NOT wanting any hard contact between them - .. Steve
Posted: Tue May 03, 2005 2:19 am
by Lbc
thanks for the reply.Something like the fabric you would use to cover a bass trap ?
Posted: Tue May 03, 2005 5:42 am
by knightfly
Here's a couple ideas I drew recently, hopefully the link will work -
http://www.johnlsayers.com/phpBB2/download.php?id=4080
HTH... Steve