John Sayers' Recording Studio Design Forum Archive

I can find density information almost anywhere for plywood, but I can't find anything for MDF or drywall. I know I've been looking in the wrong place, but I can't find anything.

I'm hoping to build some panel traps into the walls of the studio, but city fire code requires that the walls be covered with drywall. I am trying to hide as much acoustic treatment in the walls as I can, especially the bass trapping since it takes up so much space. I have a back wall that is about 9" thick that I could build panel traps into if I could find the correct information.

Any help? Designs?

Thanks all,
Scott

Lokk in IR 761. It has lots of physical parameters of building materails.

Andre

i refer to this post often ... should get you started anyway

http://www.johnlsayers.com/phpBB2/viewt ... =6306#6306

dan

Thanks Dan:

Yours is much better than mine.

Andre

Thanks! This helps a LOT!

What would I do without you?

Scott

Guys, glad this came up; I need to change the glass values to more accurate values (the 3x figure was based on previous info from Eric, I probably didn't catch the part about PRETENDING it was 3x as dense as gypsum so no one would UNDER-size glass; it's actually denser - check the link again... Steve