John Sayers' Recording Studio Design Forum Archive

Heyall

My Hr824 are located at my window. I don´t really want to build them in the wall, that would take away my precious view. Is there any way that I could screen them off to minimize the sound going backwards ? Maybe build a big stand with a back ?

Thanks,
Kalli

Aloha Kallio,

I seem to remember a post around here somewhere asking a similar question. If I remember correctly, if one were to build just the bezels for the monitors (using the correct formula for the width/height measurements) and support it on some kind of frame, fit the monitor through the bezel opening, it should work.

I can't seem to recall where it is exactly, but I think Steve (Knightfly) might have been the one who came up with the solution. Also, you might want to check out Sjoko's semi-soffit bezels here: http://www.johnlsayers.com/Studio/Mainpage/MP-Sjoko.htm
Be sure to click on all of the updates as well.

Hope this helps,

Aloha

kendale wrote:Aloha Kallio,

I seem to remember a post around here somewhere asking a similar question. If I remember correctly, if one were to build just the bezels for the monitors (using the correct formula for the width/height measurements) and support it on some kind of frame, fit the monitor through the bezel opening, it should work.

I can't seem to recall where it is exactly, but I think Steve (Knightfly) might have been the one who came up with the solution. Also, you might want to check out Sjoko's semi-soffit bezels here: http://www.johnlsayers.com/Studio/Mainpage/MP-Sjoko.htm
Be sure to click on all of the updates as well.

Hope this helps,

Aloha

Thanks Kendale

Could you explain a little about the right measurement ?

Oh, and I wish I was in Hawaii instead of Iceland right now

Kalli