Sen - It's tired and I'm late :=) so this is very crude (I just put your dwg into paint and butchered it) but it seems like if you could move the entry toward the kitchen some, you could waste less space and improve ergonomics by doing something like this... Steve
I forgot to put a door in the drum booth - you could either put the door where I chopped off the corner, or do a double slider setup in place of the window. A properly hung and caulked solid door would probably have about the same isolation as a pair of sliders, but would be cheaper.
The wall separating CR and LIVE room!?
-
- Posts: 277
- Joined: Wed Mar 26, 2003 11:07 pm
- Location: Melbourne, Australia
-
- Senior Member
- Posts: 6976
- Joined: Sun Mar 16, 2003 11:11 am
- Location: West Coast, USA
Sen, the STC of ANYTHING is largely dependent on tight fitting and proper seal. A 3 foot thick LEAD wall is still worthless if there are cracks/holes where it should be sealed.
I've got a lot of homework to take care of for a while, but I'll try to get some better examples for you of the ways doors are sealed effectively.
Here is one site with some things for study, Overly make some very good doors if you're rich (several thousand $ each) but I've learned a fair amount just from reading thru their site -
http://www.overly.com/doorCo/Education/Acoustical.cfm
And the tried and true SAE - click on construction, then doors/windows. The only change I'd make in the door pix is to NOT have any thru-latches - the loss in STC is noticeable, so I'd use magnetic seals with non-thru pulls.
http://www.saecollege.de/reference_material/index.html
Double doors are (to me, anyway) worth the agony of either expense or design time, if you're going to be moving a lot of gear in and out (commercial projects, etc) so it's worth the time it takes to research and design your own, if you can't afford $15k for two pairs of Overly double doors (that's just a guess, based on what their single doors run)
And you thought finding the MONEY for this project was going to be the hard part, din'cha??? Sympathetically yours... Steve
I've got a lot of homework to take care of for a while, but I'll try to get some better examples for you of the ways doors are sealed effectively.
Here is one site with some things for study, Overly make some very good doors if you're rich (several thousand $ each) but I've learned a fair amount just from reading thru their site -
http://www.overly.com/doorCo/Education/Acoustical.cfm
And the tried and true SAE - click on construction, then doors/windows. The only change I'd make in the door pix is to NOT have any thru-latches - the loss in STC is noticeable, so I'd use magnetic seals with non-thru pulls.
http://www.saecollege.de/reference_material/index.html
Double doors are (to me, anyway) worth the agony of either expense or design time, if you're going to be moving a lot of gear in and out (commercial projects, etc) so it's worth the time it takes to research and design your own, if you can't afford $15k for two pairs of Overly double doors (that's just a guess, based on what their single doors run)
And you thought finding the MONEY for this project was going to be the hard part, din'cha??? Sympathetically yours... Steve
Soooo, when a Musician dies, do they hear the white noise at the end of the tunnel??!? Hmmmm...
-
- Posts: 277
- Joined: Wed Mar 26, 2003 11:07 pm
- Location: Melbourne, Australia