Slot resonator door and rear wall question

Tom Zartler · Post by **Tom Zartler** » Thu Dec 08, 2005 1:43 pm

I was curious if anyone has built a door in a slot wall. I've been scratching my head on how to utalize the closet for my mic, cable and stand storage. I am about to hit the sack and just had to post.

Also, I was curious if I angled the rear wall, so it stood out on the ceiling, would I get as good results? (bottom picture).

If so which of these fabrications would be best?

1 Cloth over 703 in timber frame.
2 Cloth over 703 laminated to fiber board
or
3 Puffy fiberglass laminated to fiber board then compressed and cloth covered.

Thanks so much for any comments

Tom

Sorry for my Mikey mouse drawing

My other puter is off and takes a lifetime to turn on.

Tom Zartler · Post by **Tom Zartler** » Thu Dec 08, 2005 2:20 pm

All right, couldn't sleep.....

Here is a better idea. The walls in the rear corners would be kept angled to permit the door opening fully.

good nite